• +27 12 644 0300
  • +44 1234 834920
  • This email address is being protected from spambots. You need JavaScript enabled to view it.

Vector Linestyles Change Scales According to Annotation Scale When Read Into Other Systems

Question:

When a drawing created in Caddie is worked on in some other DWG based systems the linestyle scales of the vector lines sometimes changes with the annotation scale in the modelspace. Can we stop this happening?

 

Applies To:

Caddie 17 onwards

 

Answer:

Yes you can. The newer versions of DWG support a system variable called MSLTSCALE. If this is set to False then the linestyles do not scale in the modelspace whereas if you set it to True then they will scale in some software. You can change it in Caddie by going to Utilities -> System -> Set System Variable then following the prompts on the command line, or it can be changed in other fully DWG compatible software by their equivalent tools.

 

© 2024 Caddie Limited. All Rights Reserved.