• +27 12 644 0300
  • +44 1234 834920
  • This email address is being protected from spambots. You need JavaScript enabled to view it.

How can I show door swings on an AEC horizontal section (plan)?

By default, AEC sections don't show the door swings. If you want to switch them on, do the following:

 

Open the drawing.

 

Open AEC display manager. Select Sets -> Section_Elev and set Plan to ‘Yes’, by double clicking the cell.

 

See figure below:

 

AEC_Switch_On_Section_Door_Swings

© 2022 Caddie Limited. All Rights Reserved.